Pipeline centrifugal pump installation skills

Pipeline centrifugal pump installation tips 1, pipe centrifugal pump installation technology The key is to determine the pump installation height (ie suction). This height refers to the vertical distance from the water surface of the water source to the center line of the pump impeller. It can not be confused with the allowable vacuum height. The allowable vacuum height indicated on the pump manual or nameplate means the vacuum value on the water inlet section of the water pump, Is measured at 1 standard atmospheric pressure, the water temperature of 20 degrees Celsius, the test and measured. It does not consider the condition of the water flow after the water supply pipe is matched. The pump installation height should be allowed to suck vacuum height deducted after the head of the suction pipe loss, the remaining part of the value, it is necessary to overcome the actual terrain water absorption height. Pump installation height can not exceed the calculated value, otherwise, the pump will not pump water.

2, the impact of the calculated value is the size of the suction pipe loss of head lift, it is appropriate to use the shortest pipe layout, and try to install elbows and other accessories, but also consider the appropriate with some larger diameter pipes to reduce the flow rate within the pipe.

3. It should be pointed out that the pipelines centrifugal pump installation site elevation and water temperature is different from the test conditions, such as the local elevation of 300 meters above or pumping water temperature exceeds 20 degrees Celsius, the calculated value to be amended. Ie atmospheric pressure at different elevations and saturated vapor pressure above 20 degrees Celsius. However, when the water temperature is below 20 degrees Celsius, the saturated steam pressure is negligible.

4, from the pipeline installation technically, the suction pipe requires strict sealing, can not leak, leakage, otherwise it will undermine the pump inlet vacuum, so that the water pump to reduce the amount of water is not even pumping too serious. Therefore, we should conscientiously do the work of the interface of the pipeline to ensure the construction quality of pipeline connection.

This article Keywords Search: More Pumps Technical Articles Pumping Tubing Product Information

All-in-one Injection Moulding And Metal Stamping Service Provider

Manufactures and exports quality OEM plastic injection molding parts and plastic injection moulds

injection molding and metal stamping

DoHform Mold(China) Co,.Ltd. , https://www.dhform.com