Precautions when installing and using pulse solenoid valve

Precautions when using the pulse solenoid valve installation: 1, the best way to install the electromagnetic pulse valve is perpendicular to the horizontal pipe, the coil up. In the premise does not agree, allow ± 30 ° tilt. Otherwise, normal use can not be guaranteed. 2, the solenoid valve nameplate parameters should be consistent with the actual use requirements. 3, the arrow on the solenoid valve body should be consistent with the media flow. 4, in order to ensure the normal use of the solenoid valve, please install oil-water separator in front of the solenoid valve. 5, in a hazardous environment to prevent sparks may lead to the occurrence of explosions and other accidents, the use of explosion-proof solenoid valve. 6, before installation, please thoroughly purge air bags and piping to prevent foreign matter damage to the diaphragm caused by the solenoid valve failure. 7, when the solenoid valve fails, in order to promptly isolated and easy maintenance, it is recommended to install bypass (bypass) device. 8, electromagnetic pulse valve temporarily installed, can be stored at 0 ~ 40 ℃, relative humidity ≤ 80%, but non-corrosive gases indoors, as far as possible to avoid open storage. 9, after unpacking should first check the use of a single, the factory certificate, packing list is complete. And then check the list of product names, models are consistent, the control nameplate is consistent with the purchase order. If the defect or does not match, should promptly contact with the manufacturers ideas. Valve inlet pump Keywords: solenoid valve